Home »
Posts taggedmachine tool
Universal tool holder Preparation for commissioning Machine geometry precision test after passing the need to clean up the machine. With a cotton cloth or silk cloth soaked in detergent, shall not use cotton yarn or gauze. Rinse off the machine tool to protect the rail surface and the...
Continue reading
November 30, 2017 iendmill
cutting tool
No Comment
Turning center Turning Center: On the basis of ordinary CNC lathes, the C axis and power head are added. The more advanced machine tool also has a tool magazine which can control three axes of X, Z and C. The linkage control axis can be (X, Z), (X,...
Continue reading
November 28, 2017 iendmill
cutting tool
No Comment
The selection of cutting parameters depends on the material of the workpiece to be machined. But at the same time by the selection of cutting parameters of the machine tool, cutting tool system, many factors of workpiece shape and clamping mode, should be adjusted according to the actual...
Continue reading
September 2, 2017 iendmill
Uncategorized
No Comment
cutting of end mills When the cutting point is a concave part or a deep cavity, the extension of the end milling cutter is needed when the cutting point is in the numerical control milling process. If the long edge end mill is used, it is easy to vibrate...
Continue reading
August 28, 2017 iendmill
Uncategorized
No Comment
Lathe operation (1) Before the work according to the provisions of the lubrication of the machine tool, check whether the handle in place and the slow running five minutes, confirm that all the normal operation can. (2) The chuck shall be firmly fastened; when it is switched on,...
Continue reading
August 15, 2017 iendmill
Uncategorized
No Comment
That is, lathe processing, lathe processing is part of the machining. Lathe processing mainly uses turning tools to rotate the workpiece turning. Can also be used in the lathe drill, drill reamer taps Banya and knurling tools for the corresponding processing. The lathe is mainly used for machining...
Continue reading
August 10, 2017 iendmill
Uncategorized
No Comment
Rational use and selection of combined cutting tools In order to adapt to the manufacturing technology facing the product diversification of higher production efficiency and environmental protection requirements, have appeared in high-speed cutting, the new processing technology of dry cutting. The cutting time of high speed cutting technology...
Continue reading
August 9, 2017 iendmill
Uncategorized
No Comment
Accuracy The tungsten steel drill, first of all, needs to consider the size precision machining requirements of the drill. Generally speaking, the smaller the machined aperture is, the smaller the tolerance is. Therefore, the drill bits are usually classified according to the nominal diameter size of the machined...
Continue reading
July 27, 2017 iendmill
Uncategorized
No Comment